Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
cmd:fcels [2011/03/01 01:13]
mcb30
cmd:fcels [2011/10/26 15:01]
mcb30
Line 35: Line 35:
   *  if the port is attached to a fabric via a Fibre Channel switch, iPXE will use the well-known port ID ''​ff.ff.fe'',​   *  if the port is attached to a fabric via a Fibre Channel switch, iPXE will use the well-known port ID ''​ff.ff.fe'',​
  
-  *  if the port is attached directly to another Fibre Channel peer, iPXE will use the port ID of the peer.+  *  if the port is attached directly to another Fibre Channel peer, iPXE will use the ID of the peer port.
  
 ===== Command status ===== ===== Command status =====
Line 46: Line 46:
   * ''​[[:​cmd:​fcstat]]''​   * ''​[[:​cmd:​fcstat]]''​
   * [[:cmd|List of all iPXE commands]]   * [[:cmd|List of all iPXE commands]]
 +
 +===== Build options =====
 +
 +This command is available only when the build options ''​[[:​buildcfg:​NET_PROTO_FCOE]]''​ and ''​[[:​buildcfg:​FCMGMT_CMD]]''​ are enabled.
  
 ===== Notes ===== ===== Notes =====
cmd/fcels.txt ยท Last modified: 2011/10/26 15:01 by mcb30
Recent changes RSS feed CC Attribution-Share Alike 4.0 International Driven by DokuWiki
All uses of this content must include an attribution to the iPXE project and the URL http://ipxe.org
References to "iPXE" may not be altered or removed.